REAR FLOOR PANELS AND FRONT LEAF SPRING HANGERS

Discuss Bodywork problems here.
Forum rules
By using this site, you agree to our rules. Please see: Terms of Use
Post Reply
Nemo57morris
Minor Friendly
Posts: 11
Joined: Thu Jan 20, 2022 2:19 pm
MMOC Member: Yes

REAR FLOOR PANELS AND FRONT LEAF SPRING HANGERS

Post by Nemo57morris »

I'M LOOKING AT REPLACING THE REAR FLOOR PANELS AND FRONT LEAF SPRING HANGERS ON MY 1957 MOGGIE 1000 4 DOOR SALOON, AND I WAS WONDERING IF THERE ARE KITS AVAILABLE THAT WILL ALLOW ME TO REPLACE BOTH AT THE SAME TIME OR DO I NEED TO WELD IN THE FLOOR PANELS AND THEN WELD IN THE HANGER REPAIR SECTIONS.

THE ONLY REASON FOR ASKING IS I WOULD LIKE TO TRY AND MAKE IT EASIER TO DO THE JOB.

THANK YOU FOR ANY HELP
User avatar
geoberni
Minor Legend
Posts: 3561
Joined: Fri Aug 04, 2017 11:19 am
Location: North Leicestershire
MMOC Member: Yes

Re: REAR FLOOR PANELS AND FRONT LEAF SPRING HANGERS

Post by geoberni »

Hi
If you search the usual suppliers, there are Spring Hangers available 'on plate' or 'off plate'.
You'll need to look at how that compares to the amount of floor panel you're looking at replacing.
Basil the 1955 series II

Image
ManyMinors
Minor Legend
Posts: 2752
Joined: Tue Nov 11, 2014 9:41 am
MMOC Member: No

Re: REAR FLOOR PANELS AND FRONT LEAF SPRING HANGERS

Post by ManyMinors »

The hangers "on a plate" are still only a repair panel though. Nobody seems to sell a complete rear floor pan with the spring mountings attached. Rebuilding that are below the rear seat is quite an involved job and the rear floor pans don't come back far enough unfortunately.
mogbob
Minor Legend
Posts: 1280
Joined: Thu Apr 02, 2009 3:43 pm
Location: Esher
MMOC Member: No

Re: REAR FLOOR PANELS AND FRONT LEAF SPRING HANGERS

Post by mogbob »

Links to ESM's website
https://www.morrisminorspares.com/searc ... oor-panels

ttps://www.morrisminorspares.com/search/spring-hanger-repair

https://www.morrisminorspares.com/search/spring-hanger

Search the Forum for posts re this repair. It is absolutely VITAL that several measurements are taken from fixed points so that both spring hangers are square to the car in the right spot. Horror stories of a " professional " ??? garage that did the job , mucked it up and the owner couldn't fit his prop shaft back in the car, Repairs welded in too close to front. Nightmare.
I made a little wooden jig before taking the springs off my mate's car. One end welded at a time , using each
" end " of the batten alternately.Nut and bolt through the bracket , lifting the whole repair panel up into place.
Clamped the metal , checked the datum point measurements ( numerous ) , then fired up the welder.
Any queries , just ask. make sure the car is secure on plenty of axle stands , thick planks to spread the load.
Front wheels well chocked.
Bob
P.S This a link to a good thread on the Forum , with pictures, hoorah, and lots of advice
viewtopic.php?f=28&t=68797&p=629290&hil ... ir#p629290
mikec4193
Minor Friendly
Posts: 68
Joined: Tue Apr 26, 2016 6:48 pm
MMOC Member: Yes

Re: REAR FLOOR PANELS AND FRONT LEAF SPRING HANGERS

Post by mikec4193 »

I got mine from ESM...really nice stuff too...

Image

Image

I swapped out the spring hanger bushings too while I was in there pulling stuff apart...

I am not restoring just trying to save this old heap...

Good luck with your project....

MikeC
Nemo57morris
Minor Friendly
Posts: 11
Joined: Thu Jan 20, 2022 2:19 pm
MMOC Member: Yes

Re: REAR FLOOR PANELS AND FRONT LEAF SPRING HANGERS

Post by Nemo57morris »

Thank you to all, you have been very helpful. Ill make sure i take all measurements before tackling this job.
panky
Minor Legend
Posts: 1994
Joined: Wed Aug 20, 2014 4:12 pm
Location: Cheshire
MMOC Member: No

Re: REAR FLOOR PANELS AND FRONT LEAF SPRING HANGERS

Post by panky »

I'm sorry I can't remember who posted these originally but I found them extremely helpful

Dimensions2.jpg
Dimensions2.jpg (231.73 KiB) Viewed 890 times
Attachments
Dimensions1.jpg
Dimensions1.jpg (368.72 KiB) Viewed 890 times
Image
don58van
Minor Addict
Posts: 759
Joined: Sun Feb 01, 2009 6:24 am
Location: New South Wales, Australia
MMOC Member: Yes

Re: REAR FLOOR PANELS AND FRONT LEAF SPRING HANGERS

Post by don58van »

These may help too.

viewtopic.php?f=28&t=72622

viewtopic.php?f=28&t=67387&p=638695&hil ... ns#p638695
Scroll down until you get to the section on fitting the hanger.

Don
kevin s
Minor Legend
Posts: 1375
Joined: Tue Mar 26, 2013 8:20 pm
Location: Chelmsford, essex
MMOC Member: No

Re: REAR FLOOR PANELS AND FRONT LEAF SPRING HANGERS

Post by kevin s »

I'd check the dimensions before you start, on ours on what appeared the originals one side was 1/2" further forward than the other!

I must have measured it half a dozen times to be sure, in the end put them back correctly.
Post Reply