I had the same problem with the 1275cc MG Midget crankshaft used in my Minor and got Oselli to make and install the carrier/needle roller bearing as per the photo below.
- WDF crankshaft tail.jpg (74.63 KiB) Viewed 240 times
Toyota T50 Spigot Bush
Forum rules
By using this site, you agree to our rules. Please see: Terms of Use
By using this site, you agree to our rules. Please see: Terms of Use
-
philthehill
- Minor Maniac
- Posts: 11575
- Joined: Thu Jul 19, 2012 12:05 pm
- Location: Hampshire
- MMOC Member: Yes
Re: Toyota T50 Spigot Bush
I think that you are very wise to get an engineering firm to produce a spigot bush/roller bearing and carrier for the rear of your crankshaft.
I had the same problem with the 1275cc MG Midget crankshaft used in my Minor and got Oselli to make and install the carrier/needle roller bearing as per the photo below.
I had the same problem with the 1275cc MG Midget crankshaft used in my Minor and got Oselli to make and install the carrier/needle roller bearing as per the photo below.