This a follow up question after resolving a stuck oil pressure relief valve.
Brief history: I recently bought a 67 Traveller that the seller told me has been standing in his garage for over 8 years. The car was in nice condition and I briefly saw the engine running but don’t remember whether or not the oil light was on. The car was transported to me and on checking it over I saw that there was way too much oil in the sump. I dropped the sump cleaned it all out including the pick-up and fitted a new filter ready for flushing. When I turned it over no oil pressure! After much investigation I found that the relief valve was absolutely stuck (I thought it may have been stuck open). it wouldn’t budge, but after much effort over a few days I eventually managed to free it and found it to be. Scored along its length but the seat seemed ok.
I have now replaced the valve which now moves freely in its cylinder… I was hoping that this was the problem but after refitting everything and turning it over for about 10 to 15 seconds there is still not a flicker on a working oil pressure gauge.
To summarise:
- The engine turns freely.
- I have primed the pump through the banjo fitting and cranked the engine with the spark plugs removed.
- The relief valve has been replaced with a freely moving one.
- after cranking the oil filter bowl is filled with oil (does this indicate the pump is primed and working)
- The mechanical gauge still reads zero.
Given that the fact it was previously overfilled and that the sump and pick-up was very sludge up, is it likely that there is a blockage in the oil galleries somewhere? If that’s the case is it an engine out and strip?
Any ideas as to how to progress this would be great.
Thanks Alan
Zero oil pressure
Forum rules
By using this site, you agree to our rules. Please see: Terms of Use
By using this site, you agree to our rules. Please see: Terms of Use
- svenedin
- Minor Legend
- Posts: 4986
- Joined: Fri Aug 29, 2014 9:27 am
- Location: Surrey
- MMOC Member: Yes
Re: Zero oil pressure
This thread might help.
https://board.mmoc.org.uk/viewtopic.php?t=66310
The link to the diagram doesn't seem to work.
Oil pump priming bung arrowed.
Stephen
https://board.mmoc.org.uk/viewtopic.php?t=66310
The link to the diagram doesn't seem to work.
Oil pump priming bung arrowed.
Stephen
1969 1098cc Convertible “Xavier” which I have owned since 1989.
Stephen
Stephen