Oil pressure relief valve issue

Discuss anything Morris Minor related.
Forum rules
By using this site, you agree to our rules. Please see: Terms of Use
Post Reply
Albuzz
Newbie
Posts: 3
Joined: Wed Nov 18, 2026 11:44 pm
Location: UK
MMOC Member: Yes

Oil pressure relief valve issue

Post by Albuzz »

Good morning all,

Can anyone please give me their expert views regarding a stuck but now freed out pressure relief valve.

Brief history: I recently bought a 67 Traveller that the seller told me has been standing in his garage for over 8 years. The car was in nice condition and I briefly saw the engine running but don’t remember see whether or not the oil light was on. The car was transported to me and on checking it over I saw that there was way too much oil in the sump. I dropped the sump cleaned it all out, new filter ready for flushing. When I turned it over no oil pressure! After much investigation I went remove to the relief valve but guess what, it wouldn’t budge. After much effort over a few days I eventually managed to free it.

The question is this, the valve is very scored along its length maybe due to its reluctant removal but the nose appears to be ok. If I replace it with a new one, will it do its job assuming the nose/face of the valve and its seat are ok or will the possibility of corresponding marks in the block cause problems.

Any advice would be welcomed.

Thanks
Alan
mike1864
Minor Fan
Posts: 468
Joined: Tue May 17, 2011 10:06 pm
Location: Hertfordshire
MMOC Member: Yes

Re: Oil pressure relief valve issue

Post by mike1864 »

Is there more to this?
For instance, why not drain the "excess" oil via the drain plug, rather than the much messier/fraught business of dropping the sump prior to a flush?
And how does the OP know there's no oil pressure? Is it just the warning light being lit (could be a faulty sender). Or is there an aftermarket gauge?
philthehill
Minor Maniac
Posts: 12021
Joined: Thu Jul 19, 2012 12:05 pm
Location: Hampshire
MMOC Member: Yes

Re: Oil pressure relief valve issue

Post by philthehill »

The factory fitted bullet valve is prone to sticking especially if the oil is old and gritty. I would just obtain a new bullet and fit it with a new spring. Replace the cap copper washer at the same time.
You can replace the bullet with a ball bearing but it does mean adjusting the spring length to get the max oil pressure right. The best oil pressure is around 50lb. Any higher and all you are doing in creating heat and using engine energy.
oil spring.JPG
oil spring.JPG (97.83 KiB) Viewed 252 times

Albuzz
Newbie
Posts: 3
Joined: Wed Nov 18, 2026 11:44 pm
Location: UK
MMOC Member: Yes

Re: Oil pressure relief valve issue

Post by Albuzz »

Thanks for the replies….

To answer Mike, the oil was obviously filthy so dropping the sump was the right thing to do .. the oil, the filter and the strainer were full of black sludge. I tested the pressure using a test gauge so definitely zero pressure. I’m fairly certain after cleaning the pickup that it’s not drawing air there (I think that’s why it may have been overfilled by the previous owner). So that pointed me to the relief valve which if stuck open is hopefully the cause.

I’ll try replacing the valve and spring and hope that does the trick (I have tried priming the pump).

Thanks
Post Reply