Just answered a question about the adjustable oil pressure relief valve on the MMOC Facebook page and thought I would post on here.
The valve has been replaced with a 5/8" ball bearing, a ball bearing cup, a shortened spring, a top plate for the adjuster screw to press against (otherwise the adjuster screw goes down through the centre of the spring) and a modified cap with 1/4" UNF adjuster cap headed screw with locking nut.
Modified relief valve.jpeg (28.89 KiB) Viewed 1112 times
That looks like a useful modification what is the normal pressure setting?...Also does the ball sit in the conical seat within the block and does that normally need any work whilst carrying out this mod if the seat is worn or high mileage?
60psi is a good working pressure. Anymore and all you are doing is making heat and taking power.
The ball sits in the conical seat of the insert in the block. Normally no work is required to fit this mod. If the insert is worn it can be re-ground (see BMC wksp manual for details) in place and the inserts are available and relatively easy to replace. This mod has been around for a long time - all I have done is refine the details.
Below is a drawing of the insert:-
Oil pressure relief valve seat..jpg (37.18 KiB) Viewed 1072 times
Looks good Phil.
Does it leak oil past the adjuster screw?
I suppose the diameter of the ballbearing/spring cup is the same as the standard pressure valve?
Finished rescuing a 1967 2-door. Define finished....
I have to say that shortening the standard spring Pt No 6K853 is really of no benefit. The main benefit in fitting the ball bearing is that it has less tendency to jam either in the open or closed position than the cup type valve.
Hi,
I followed Phil's advice on here many moons ago and fitted the Mini ball bearing with the original spring, this improved the oil pressure and, as stated (and I found and had to faff about to get it out!) the ball bearing doesn't jam in place like the original cup valve did.
Link to original post below.
Best wishes,
Mike.
1954 Series 2: 4 door: "Sally" -- Running again, extracted from the garage, just needs the engine running fine tuning.....
1970 Triumph Herald 1200: "Hetty" -- In the garage as she's not revving properly........
1952 Morris Minor MM highlight with sidevalve engine, wants work, now also in the garage......
