1958 Two door saloon restoration in Sweden

Let us all know what you are up to with your current restoration project. Get that Minor on the road!
Forum rules
By using this site, you agree to our rules. Please see: Terms of Use
RustAndMagic
Minor Friendly
Posts: 52
Joined: Mon May 25, 2026 12:26 pm
Location: Sweden
MMOC Member: Yes

Re: 1958 Two door saloon restoration in Sweden

Post by RustAndMagic »

I got new bumpers, hinges for trunk and hood, missing chrome parts otherwise and some new rubber parts including piping for rear wings, so I will remove hood and trunk lid also to paint them separate as I want paint under the hinges.

The paint is in good condition so I will leave it there and just sand it down, put epoxy primer over all, fix any scratches and the bad area on the front wing, make it flat and nice, more epoxy primer and paint on top of that (single stage, no clear), I did it before on my Dodge Lancer so it should be ok, it will not be a show car, but that is not what I am after either.

Bought vinyl for the interior (white), can't have red interior with a blue car, not sure what to do about the seats yet (worn maroon vinyl).

I cannot see any bad rust under either so I think I got lucky there, breaks look brand new and the brake hoses are new.

Well, that was all for today.
Morris Minor Saloon 1958
RustAndMagic
Minor Friendly
Posts: 52
Joined: Mon May 25, 2026 12:26 pm
Location: Sweden
MMOC Member: Yes

Re: 1958 Two door saloon restoration in Sweden

Post by RustAndMagic »

Floor is looking good, there are some repairs, but they are well done, no rust and no holes, there was some water at the rear seat foot area and it started to get some surface rust there, but not too late to stop it.

Just red rust protection paint there now, so there is room for improvement there.
floor2.jpg
floor2.jpg (112.35 KiB) Viewed 2712 times
floor1.jpg
floor1.jpg (160.05 KiB) Viewed 2712 times
Morris Minor Saloon 1958
RustAndMagic
Minor Friendly
Posts: 52
Joined: Mon May 25, 2026 12:26 pm
Location: Sweden
MMOC Member: Yes

Re: 1958 Two door saloon restoration in Sweden

Post by RustAndMagic »

Well, it is getting there, it is now Honolulu blue, all is painted, now I "just" have to put everything back together, most rubber will be new, new bumpers, new chrome parts (hinges and so on).

I did get a few runs in the paint of course, so I have to wait a few days before I take care of them, otherwise the paint is pretty good, some polishing will be needed of course.
blue1.jpg
blue1.jpg (204.47 KiB) Viewed 2187 times
That photo does not show the color correct, this is a better representation of the actual color.
blue2.jpg
blue2.jpg (188.35 KiB) Viewed 2185 times
Morris Minor Saloon 1958
RustAndMagic
Minor Friendly
Posts: 52
Joined: Mon May 25, 2026 12:26 pm
Location: Sweden
MMOC Member: Yes

Re: 1958 Two door saloon restoration in Sweden

Post by RustAndMagic »

Almost finished now, painted, new rubber and new chrome to replace the bad parts. all glass got new rubber also, the only thing missing are the door cards and seats, the need new vinyl, but I will put in the old parts for now, it's getting winter so it will have to wait a little.

Yes, there is some orange peel, but there are plenty of paint so it will polish away, just more work.
New chrome on trunk
New chrome on trunk
z4.jpg (98.09 KiB) Viewed 122 times
New glass rubber
New glass rubber
z3.jpg (128.83 KiB) Viewed 122 times
New chrome on hood
New chrome on hood
z2.jpg (102.37 KiB) Viewed 122 times
New floor mat on the way
New floor mat on the way
z1.jpg (200.88 KiB) Viewed 122 times
Morris Minor Saloon 1958
User avatar
svenedin
Minor Maniac
Posts: 5026
Joined: Fri Aug 29, 2014 9:27 am
Location: Surrey
MMOC Member: Yes

Re: 1958 Two door saloon restoration in Sweden

Post by svenedin »

Well done. Great to see your car coming together. Isn't it getting a bit cold for painting in Sweden? I know that at this time of year I can usually only restore small parts in the house because my garage is unheated and too cold. I have tried of course and made a mess of the painting jobs!

Stephen
1969 1098cc Convertible “Xavier” which I have owned since 1989.

Stephen
Post Reply