Is it good ?

[Sandun]

Hi Can u tell me this Igniation coil Good for Morris that use Dynamo.[frame][/frame]

[bmcecosse]

It appears to show '12v' on the side - so it should be ok - but that also looks like a 'ballast' resistor.... so in that case it would not be ok - unless you are intended to use the ballast in series with the coil all the time. Can you measure the resistance (ohms) across the terminals?

[Sandun]

Seem to be The old lucas coil out big HT bz of that the normal cheep condensers burn out soon - i Looked for buy a coil so i cant found coil without Ressister part - think the resistence 3.2 with ressiter part.

[bmcecosse]

WITH the resistor connected in series - if it is 3,2 ohms then it will be finee