I'm about to reassemble the Moggy (Jody) but the cylinder head gasket does not have "TOP" on either side. One side is copper and the other is a black material (plastic???) wi[th the copper showing through where the "fluid" holes are.
Which side should be up mating with the head. Any ideas please.
Cylinder Head Gasket - Which way up?
Forum rules
By using this site, you agree to our rules. Please see: Terms of Use
By using this site, you agree to our rules. Please see: Terms of Use
-
chrisryder
- Minor Legend
- Posts: 2217
- Joined: Mon Nov 15, 2010 11:44 pm
- Location: West Midlands UK
- MMOC Member: No
Re: Cylinder Head Gasket - Which way up?
I'd suggest Copper side up, but it shouldn't really matter.
Just be sure to offer up the gasket to the head and block separately, to make sure no holes could be blocked. If there are holes blocked, turn the gasket over and try it that way!
Just be sure to offer up the gasket to the head and block separately, to make sure no holes could be blocked. If there are holes blocked, turn the gasket over and try it that way!
Re: Cylinder Head Gasket - Which way up?
A decent gasket will have words like "Top" and "Front" stamped on it 
Re: Cylinder Head Gasket - Which way up?
It doesn't really matter....but an 'all copper' gasket would be better. I would put the copper side up - since the head will be hotter than the block.
