Indicater stem light
Forum rules
By using this site, you agree to our rules. Please see: Terms of Use
By using this site, you agree to our rules. Please see: Terms of Use
Indicater stem light
Any ideas as to why my indicater stem light flashes once then stops? This is one of the many jobs I have to do as it failed the mot! Indicater still works just the stem light flashes once then stops! Any ideas!
tedlogan
tedlogan
-
- Series MM Registrar
- Posts: 10183
- Joined: Sun Jul 24, 2005 11:39 pm
- Location: Reading
- MMOC Member: No
Re: Indicater stem light
Are all your indicator bulbs working?
Could be a faulty flasher unit
Could be a faulty flasher unit
[sig]3580[/sig]
Re: Indicater stem light
Yes all four bulbs work fine and continue to flash after the green stem light cuts out!
Re: Indicater stem light
Flasher can, is that a relay?
Re: Indicater stem light
Theres more to an indicater than meets the eye! What is a flasher can? Where does it go? Is it easy to replace?
Re: Indicater stem light
Usually a silvery can with 3 terminals on the base - screwed to the engine side of the bulkhead, near the control box. Modern units are of course plastic devices, usually black......



-
- Minor Friendly
- Posts: 62
- Joined: Sun May 16, 2010 10:20 am
- MMOC Member: No
Re: Indicater stem light
My flasher unit/can is on the inner drivers side wing.Ihave a problem with mine at the moment,had two spare new ones(not Lucas) which don't work properly but have a lucas one in the post which I hope will cure it
-
- Series MM Registrar
- Posts: 10183
- Joined: Sun Jul 24, 2005 11:39 pm
- Location: Reading
- MMOC Member: No
Re: Indicater stem light
Is the flasher unit wired up correctly?
Is it the correct rating 42 +5 W?
Is it the correct rating 42 +5 W?
[sig]3580[/sig]
-
- Minor Friendly
- Posts: 62
- Joined: Sun May 16, 2010 10:20 am
- MMOC Member: No
Re: Indicater stem light
New flasher unit fitted and indicaters work a treat,however for some reason the light on the indicator stalk is on permanantly when the ignition is on,anybody got any ideas?
Re: Indicater stem light
Is it a 3 terminal flasher unit - have you wired it correctly? I suspect not! Swap the wires around....



-
- Minor Maniac
- Posts: 6004
- Joined: Tue Jul 20, 2004 11:41 pm
- Location: lanark
- MMOC Member: No
Re: Indicater stem light
i think plain light green goes to the center terminal
-
- Minor Friendly
- Posts: 62
- Joined: Sun May 16, 2010 10:20 am
- MMOC Member: No
Re: Indicater stem light
Certain it's wired up properly,can't remember what happend when swaping terminals but it wasn't correct.Put the old one back on which worked perfectly for a minute or so then packed in again.I've a fealing the replacement flasher unit is also duff!!
-
- Series MM Registrar
- Posts: 10183
- Joined: Sun Jul 24, 2005 11:39 pm
- Location: Reading
- MMOC Member: No
Re: Indicater stem light
Green - Fuse to Term B (or X)
Green/Brown - Ind Switch to Term L
Light Green - Warning Light to Term P
12V 21Wx2+5W
Green/Brown - Ind Switch to Term L
Light Green - Warning Light to Term P
12V 21Wx2+5W
[sig]3580[/sig]
Re: Indicater stem light
Indeed - but just a chance the terminals inside the flasher have been connected wrongly.



-
- Minor Friendly
- Posts: 62
- Joined: Sun May 16, 2010 10:20 am
- MMOC Member: No
Re: Indicater stem light
Just fitted yet another flasher can,stalk light stays off however front right indicater won't come on!
1.Bulb works fine when swapped to other side
2.Continuity seems ok from bulb holder to power feed
3.Continuity through green/white wire (control box to indicator green feed) seems fine
4.Swapped the feed to use left indicator at controll box and this works
So after all the flasher canns I'm presuming that the control box is at fault?
1.Bulb works fine when swapped to other side
2.Continuity seems ok from bulb holder to power feed
3.Continuity through green/white wire (control box to indicator green feed) seems fine
4.Swapped the feed to use left indicator at controll box and this works
So after all the flasher canns I'm presuming that the control box is at fault?
