Hi My Traveller has failed its mot!
Nearside front lower suspension arm has excessive play in a pin/bush as does the offside front upper and lower pin/bushes. My question is what are the exact names for these when ordering and is it just a pin and a bus x3 ill need? Cheers
Mot failure
Forum rules
By using this site, you agree to our rules. Please see: Terms of Use
By using this site, you agree to our rules. Please see: Terms of Use
Re: Mot failure
http://www.moss-europe.co.uk/Shop/ViewP ... exID=17091
You'll need bushes 23 and 73 - get the polyurethane ones. But is the wear at the outer pins on the lower suspension arms ? If so - you may get away with new fulcrum pins (item 99) through the trunnions - often the pins wear much more than the bushes. Or - you could fit new lower trunnions - bit more expensive - but sure to take up the wear completely. MOSS don't seem to list them as complete units - but do ask. Other suppliers can do all these parts of course - I just used MOSS for the excellent diagram!
You'll need bushes 23 and 73 - get the polyurethane ones. But is the wear at the outer pins on the lower suspension arms ? If so - you may get away with new fulcrum pins (item 99) through the trunnions - often the pins wear much more than the bushes. Or - you could fit new lower trunnions - bit more expensive - but sure to take up the wear completely. MOSS don't seem to list them as complete units - but do ask. Other suppliers can do all these parts of course - I just used MOSS for the excellent diagram!



-
- Minor Maniac
- Posts: 7845
- Joined: Thu Jan 25, 2007 3:18 pm
- Location: South East London
- MMOC Member: No
Re: Mot failure
BMC is probably right but "Nearside front lower suspension arm has excessive play in a pin/bush" doesn't help much as there is a pin one end and a bush the other.
Most MOT guys will happily point out exactly where the problem is, and even show you the wear if you ask.
Some put a chalk or crayon mark on failure points to speed up the retest.
Most MOT guys will happily point out exactly where the problem is, and even show you the wear if you ask.
Some put a chalk or crayon mark on failure points to speed up the retest.
"Once you break something you will see how it was put together"