1098cc Flywheel

[jaguar68]

Hi Guys,

I've got a serious problem with my 1098cc flywheel I hoped to have drilled to fit the 1275cc A+ Ital crank.

I've had it drilled, however, the "specialist" who drilled it has put the holes in the wrong places. Theoretically, the holes should be on a hexagonal pattern, but no matter how I try, I cannot get the holes to line up.

Is it possible to have the flywheel centre machined out and replaced with a correctly drilled replacement centre?

Regards

John

[linearaudio]

Sounds very unlikely to succeed! Your best move would be an ad in the wanted section for another flywheel, and find another "expert" machinist! Someone may even have a ready-drilled one to dispose of!
Edit: Just noticed your ad in wanted section

[mike.perry]

Get it wrong and the engine will be horribly out of balance.

[bmcecosse]

Two of the original holes are fine - you only need to drill 4 more. Your 'expert' sounds like a real liability! Even I managed to do this - at home -with a leccy drill. It's hardly rocket science. Another flywheel will be the best way forward.......