Stage 3 12G202?

Discuss mechanical problems here.
Forum rules
By using this site, you agree to our rules. Please see: Terms of Use
Post Reply
Alec
Minor Legend
Posts: 2148
Joined: Thu Apr 15, 2004 7:29 am
Location: Oswestry, Shropshire
MMOC Member: No

Post by Alec »

Hello all,
just a quick note regarding machining the 1098 block. As I am fortunate eough to have a lathe at home I made up a mandrel to fit a small diameter grindstone. Using this and the head as a jig I ground the pockets using a standard power drill to drive the grindstone. This worked quite well, albeit a little slow as the stone was a fine grade one.

Alec
Top
Post Reply

Return to “Mechanical”