door seals/ draught excluders

Post by **kessey** » Wed Oct 03, 2007 9:00 am

hi i have a 1964 morris 1000 and im finding it difficult to fit the seals around the door on. everytime i break the little clips and its hard enough to get them on in the first place because they are so small.

is there an easier way

thanks louis

Post by **RogerRust** » Wed Oct 03, 2007 12:44 pm

You can get a modern equivalent seal it goes on without the clips. Any of the big suppliers stock it

Post by **Peetee** » Wed Oct 03, 2007 5:54 pm

You can get a modern equivalent seal it goes on without the clips

I've used this but it does require a bigger gap around the door. this is adjustable (via the striker plate) at the rear, but the front edge might prove to be a problem.

Post by **youngun** » Wed Oct 03, 2007 6:23 pm

I have got some of this trim from Woolies, and i have made a little slider to widen the clip gap before i try and put the trim on. Its just a screwdrive which ive ground down a bit! Works a treat.