inner wing

Post by **dustyfog** » Fri Jun 29, 2007 5:42 pm

refrence to the rear inner wing problem i'm having , the panel was made in sri lanka and is too short in height as well in length. as we all know, i put in a phone complaint to the supplier, but to no avail as the return time had ended ( my fault ) so i need another panel to replace this one. does esm do a bit better rear wheel arch as hadrians panels do not make them anymore. I don't have the equiptment or tooling to fabricate my own and the old inner arch was more or less scrap after it had been taken off. in regards to the panel being two inches to short there is a bridging panel avaliable from mmc in bath many thanks dustyfog

Post by **philb** » Sat Jun 30, 2007 10:27 am

Have a chat with Steve Parker 01580 200062 he runs ESM workshop. Great guy, very helpful. May have some ideas for you.

Post by **jonathon** » Sat Jun 30, 2007 10:50 am

Dusty, I mentioned on the other thread relating to this matter, that the only other manufacturer of these panels is not aware that they are missing a golden opportunity to make some sales. Unfortunately this company also 'can' supply many other panels which are better than any other available, but 'probably' because the minor market is so small in comparison to modern stuff , they are unwilling to make anything.

Post by **chickenjohn** » Sat Jun 30, 2007 3:39 pm

Yes, phone ESM- they are really good.