Gearbox Problems
Forum rules
By using this site, you agree to our rules. Please see: Terms of Use
By using this site, you agree to our rules. Please see: Terms of Use
-
- Minor Friendly
- Posts: 31
- Joined: Fri Sep 02, 2005 5:26 pm
- Location: Belper, Derbyshire
- MMOC Member: No
Gearbox Problems
I am having problems changing up from 2nd to 3rd gear, changing down from 3rd to 2nd however is fine All the other gears are ok including reverse. Before I go down the route of taking out the gear box could anybody give me a pointer as to where the problem may be. Could it be the plastic bush in gear lever selector ?- might be worn.
Well worth pulling the lever out and inspecting it - doe the lever have loots of 'slop' ? next stage will be to drain the oil and remove the side inspection plate - watch out for two little springs as you take it off. Here you can inspect the selector forks - especially the little bolts holding them to the sliding rails. The 3rd / 4th selector may have come loose on the shaft - although this would show at the lever as excessive movement in 3/4 gears compared to relatively little movement in 1/2 gears.



-
- Minor Addict
- Posts: 754
- Joined: Fri Apr 16, 2004 10:10 pm
- Location: london
- MMOC Member: Yes
-
- Minor Legend
- Posts: 4064
- Joined: Tue Dec 07, 2004 8:50 am
- Location: Margate, East Kent
- MMOC Member: No
Are you consciously moving the gear lever forward and to the right then forward in a deliberate movement? Pause briefly in neutral.
Modern FWD gearboxes make for lazy drivers and lazy diagonal gear changes from 2nd to 3rd. try this in a Moggie and you will get a crunch as you are really trying to go into 1st. It catches out virtually every new Moggie driver who has come from a modern car.
Modern FWD gearboxes make for lazy drivers and lazy diagonal gear changes from 2nd to 3rd. try this in a Moggie and you will get a crunch as you are really trying to go into 1st. It catches out virtually every new Moggie driver who has come from a modern car.