Morris Minor Owners Club

Hi anyone purchased a new RB 106 of late. if so from what supplier. and was it genuine or Chinese?

Thanks for the info Phil, I purchased a spring from Moss and fitted it with a bit of a struggle but went OK and works fine.
George

Thanks for that, do you know if they are the same for the series MM? on the web site you gave me it states 803 and the mm is a totally different set up.

Hi, can anyone give me the dimensions of the clutch pedal return spring ie diameter and length or better still have one they are willing to sell.
Regards George.

Hi I am needing a front seat for modifying (lowering as I have a neck problem with bending my neck forward) it does not matter of condition of the upholstery as I will recover to match existing when finished. I have heard other later seats fit the Morris for this purpose but which ones I do not know...

Hi Rob slip ring sorted, my finger to the slip ring did`nt have anything for the purple wire from under the dash to connect to once this was realised it was plain sailing, my 80 year old brain works slowly. that done it worked ok, but now has stopped I think its an earth problem any ideas on that ? ...

Hi Rob.back again!. I connected from the slip ring to the wire in the horn button with my tester that was ok. I also checked from the horn button wire to the finger same result the tester lit. I am now at a loss what to try next, could there be a fault in the insulation pieces or the hooter itself, ...

Thanks yet again Rob. when I connect that wire the horn goes all the time, so it must be shorting somewhere I have checked the horn push that seems ok, reconnected the insulated parts several times to no avail, any further ideas

Thanks for that Rob, how does power get to the finger? sketch would help me.

Hi can anyone advise me on the slip ring horn assembly including where the wire from the horn connects too, only every part seems to be insulated against making a connection to the steering column for the horn to work.

Thanks for that Rob, it seems to fit the round hole more than the square hole behind the water pump on the side face of the engine block, comments please.
regards NSN

Help required, I have removed the water jacket owing to a leak on my 1953 high light MM and a metal spreader for want of a proper term, fell onto the floor and now I do not know where it came from or where it fits I can find now mention of it in the parts books or manuals I have, Mine is fitted with...

Hi, can anyone tell me if the inner choke cable on a MM Highlight is a single wire or stranded wires.

Another question, wheres the best supplier for series MM carpets in Maroon ??

Thanks for that pete I will ring them after I measure the glass
George

Hi Guys anyone know were to buy the felt that goes inside the window channel for the glass to run in, tried Woolies but his is too thick, I think it wants to be about 4mm thick x 28 to 30mm wide, please please advise

thanks for that Many Minors, now to find some to purchase

Help!!! I am putting together my 53 high light at last and noticed small holes on the underside of the wing where it meets the front valance are these to fit rubber buffers into ? like I see advertised for later models any idears out there please

Thanks for the info Rob sounds like I am going to be busy with paper templates and sore knees after I have removed the dash ect

Hi I am seeking info on the original insulation used on the bulkhead, what it is like and how far it went down inside the car, or was it only behind the dashboard ? hope there is info out there