Morris Minor Owners Club

AKD530 Manual is available to download from Internet for free and contains a section on fitting belts to the various models in section R

If standard the pump is under the bonnet, passenger side on side of battery compartment. It has no fuse with ignition on 12v to terminal and make sure earth is ok. With ignition on give it a tap and see if it starts clicking, it has points that maybe stuck. Mine is electronic type as it says on labe...

A response today to a 22 year old post, surely a record

The only place for electric cars is Scalextric track

Have you checked you are getting full throttle, it can rev out at part throttle with no load but not when under load.
Also is tank breather clear, try with fuel cap loose

Or here is the T into original switch position, not as accessible maybe, although my vacuum advance position doesn't help but it could be repositioned.

If you use the search, lots of posts about fitting oil pressure gauge, either T at oil pressure switch or remote mount T piece.

Nearside checked, only one washer so the left hand threaded nut was tightening on end of thread but still had bearing play.with two washer fitted, same as off side, the taper bearing now adjusts normally. It was this that made it feel like parallel bearing, as fully tightened nut did not adjust the ...

Phil posted some excellent info on bushes
viewtopic.php?p=675996&hilit=Poly+bush+hardness#p675996

I don't know if still available but vinyl weld used to be the go to

Some cars if you left indicator switch in either left or right and switched off the ignition the front and rear side light illuminated on one side only. Marking parked car without having 4 lights draining battery. I believe parking lights were required on unlit Road.

Thanks Phil the castellated Marina locking ring is what I have but fitted over a castellated nut that has possibly been ground down to give the right depth for the locking ring to align with split pin hole in stub. At least I now know I have minor stub axles, in the winter I will pull a hub of compl...

Hi Phil finally got to remove outer wheel bearing and would appreciate your comments on what I have. You were correct the bearing are tapered There are 2 washer, one slightly thicker between adjusting nut and outer bearing. The castleations look quite shallow but the nut has a push over cover for th...

Drilled through chrome triangle in front of quarter light, it's still useable. Could do with passenger side having slightly longer arm, it's fine driving but would benefit when reversing to see back wheel.

I will try to post a video. This morning I took car for a short run to warm up. Rattle noice still there. It seems to be within a fairly narrow mid rev range. I can get rid of it by modifying speed and / or changing gear. With the engine warm I pulled off each plug lead in turn and reved the engine...

Hook Norton Brewery classic cars and bikes

Perhaps post a youtube video so we can listen very difficult from a description. Have you tried pulling a plug lead off and try with each cylinder not firing in turn to see if one makes any difference? No harm to rev up on 3 cylinders :tu1: Does crank pully seem secure as you mentioned you thought d...

Back where it belongs

Maria1959morris wrote: ↑Thu Apr 11, 2024 3:57 pm Wee picture of progress

1st time paint is so good it jumped into a different post