Morris Minor Owners Club

Yes the separator is clear, I’ll check the cap.

Stephen, you might need to wipe the oil away and from then on keep an eye on where it appears again, after gentle motoring. As I suspect it has blown all over the place when on the move at higher speeds. Weather looks to be getting better, good luck.

Well I’ve got a slight oil leak and before I do anything drastic, I wanted the best breather system possible, to eliminate that.

I actually fell asleep, when I woke up it was still trying to connect !!

Below is my current set up, I have another manifold to suit a PCV valve installation, would changing to this give better breathing, or at least be worth doing ?

Hope the modifications go to plan, on a personal note, and it’s just my view, it’s not worth it !

Excuse me butting in but this may help

Look at all the fun you’ve missed trying to fit them !

I presume he wants the 8 cwt version, with the heavier steering arm.

You can complicate everything if you try, the above is a fine example !
I think Mr Spigot just wants to check a few electrical things on his Minor.

The grease in question that I have, was manufactured 5 years ago last week ! I took a chance and used it

Well that was a surprise to me. You’re always learning !
Thanks for your post.

I was looking for some general purpose grease today, found some and noticed printed along with other stuff, that it was usable up to 5 years from manufacture date. I didnt know that !! Regarding sealed V open bearings, I’m going for open. Apparently ESM supply ones made by FAG, the sealed ones I hav...

Thanks for all comments, one more thing if I may. I’m replacing the bearing while I’m there, however the bearing I have is sealed, whereas the original was standard, I have ordered a standard bearing (open) as I think packing with grease would be better. What is the advantages of a sealed bearing ? ...

Yes sorry, more relevant in Mechanical.

Is this assembly correct ? I haven’t got the manual with me, where I’m working, and foolishly didn’t observe the positioning before dismantling. The left hand spring is not sitting vertically ? I think the shoes are in the correct orientation to each other ? I had a struggle fitting them, is why I’m...

Great, hope it goes well !

The analogue one shown should cover all your everyday needs.

There is a company called Jentree in Uckfield that do body work, they are good but doubtful any more affordable than ESM.

Nice job Phil, fortunately my steel plates are still serviceable.
Regarding the bush position ———— Blue thinner flange through chassis, Red thicker flange through spring.