Morris Minor Owners Club

hi mickey c u hav new chassis any chance u b able to give me size of it cheers

I think the 2 new back legs I have welded in are to high I have taking a straight edge from the bottom flat of chassis under seat area out to the back leg then measured up to top of leg or up to shackle pin hole . this is size I need . hope you can understand what I mean as not good at describing th...

sorry but those sizes are irrelevant to what I need thanks anyway

does any one have there chassis on jig so can get some sizes

hi les is there any way you can give some sizes . from ground up to front pin spring hanger .And from ground up to BACK chassis leg

ok understand now thanks

are u sure you have they panels the right way

heres photo of the rear[frame][/frame]

this is the problem here

yes I got panels from mm centre Birmingham(rep 608 ) & ( rep609 ) I have taken some photos will try my best to download them thanks for getting back cheers

ok thanks will get some tonight

can any one help me with fitting panels to van back at end of chassic as back seems to be to low down

hi can anyone tell me the length of u bolts for 8 leaf spring on van cheers

cheers will give them a go

can anyone tell me best place to buy roof gutter for my van cheers

I had a issue with new front wings lining up as well. The gap between the wing and edge of the bonnet was too tight because the edge were the wings bolts to the top of the flitch was sitting at a raked in angle. Some careful bending and tapping with a hammer and dolly straightened this up and left ...

bmcecosse wrote:If it's new panels - they always need 'adjustment'...

ok thanks for getting back to me will need to get some photos done to show you think got ma work cut out on this one

Are these new parts you have fitted (and if so - what other parts have been fitted...) - or are you just trying to realign what's already on the vehicle? not all new parts new inner wings full flitch panels . same wings and bonnet and cowl think problem may be cowl panel was just using it to get me...

POMMReg wrote:What problems are you having?

main problem is gaps between bonnet and wings also holes not meeting cowl and wings