Morris Minor Owners Club

Hi Thanks bmcecosse for your suggestions. When I did the last set of tests I compared the two front indicator units and discovered that the right one had an earth wire which the LH was lacking. This is strange as the LH indicator has worked in the past without a separate earth wire, I suppose earthi...

Hi all Some observations of my LH front indicator/pilot light 1) Pilot lights work fine. 2) With pilot lights on, LH indicator on, front indicator bulb does not flash but pilot lamp and rear indicator lamp flash very slowly, no warning light or sound in car 3) With pilot lights off, LH indicator on,...

Hi, thanks for replying so quickly. With the small lights on the rear flasher is normal, but front flasher is very weak and hardly visible, the warning light on the stalk does not light at all.

Thanks

Hi Many thanks for your replies. Have now had a chance to try to fix this. I have now replaced pretty corroded light bulb holders at front and rear on the problem side but the problem persists. The indicator is flashing but the warning stalk light only flashes once and their is no tick tock sound, b...

Hi, thanks for replying, I think I needed to seat the bearing rather than tap the hub back on as it appears to naturally go further along the axle tube and push the bearing back off if tapped to far

Hi all, have sorted it, I didnt understand that the metal ring was part of the seal as the rubber had deteriorated, the metal seemed to be part of the hub, fairly easy to get the metal ring out when i understood it was seperate. But now when I refit the hub it is pushing the bearing out of the hub. ...

Hi

I am overhasuling a rear hub and wanted to replace the oil seal. I have removed the rubber but this has left the metal ring outer part of the seal in situ which I cannot seem to remove. Any thoughts on removing it would be appreciated.

Thanks

Hi Hoping this might be an obvious fault to someone. I have a 1964 1098cc traveller. My indicators have been working fine until recently when the following fault developed. The RH indicator works normally and the stalk light flashes as normal and the tic toc sound can be heard . On the LH side when ...

Yes it is the same size, 35mm x 72mm x 17mm. I will try to re-fit, when it stops raining here!

Hi, thanks for your reply, sorry the bearing is being pushed out when I tap back the hub by about 3-4mm.It doesnt seem to want to go back. The half shaft cannot be fitted. As far as i understand the 6207 is the bearing for the rear wheel and yes the 2RS has two seals. Thanks

Hi, am fitting new rear bearings to 1964 Traveller, using sealed bearings RHP 6207 2RS made by Zen but when tapping hubs back they are pushing the seals back out. Should the hubs be fully knocked back or can I leave a space to tap the bearings flat, or are these seals not correct ? Thanks