Morris Minor Owners Club

Will do
Thanks again
Richard

Many thanks for that.
I have e-mailed John but not had a reply as yet .. Maybe my mail went into a junk folder as it was sent from my work e-mail ..
Anyway thanks again
Richard

Thanks for the reply. I have tried spraying in the past and made a bit of a c... of it. I have done all the primer so just looking for someone who knows what they are doing to finish it. Also with the spray paint these days can be a bit nasty so not sure if I want to get involved in that... Many tha...

I am getting near to the point on my restoration where I have to find someone to paint my moggy ! Does anyone know someone in the Leicester area they would recommend to do the job for me ? Not looking for concours just a nice paint job as I am planning to use the motor as a daily driver ! ... During...

moggie-tom wrote:Did anyone else hear that he did the last four races with a broken shoulder?

Yep crazy Aussie He didn't tell the team either .... bad lad !

Mercedes C9 Group 'C' sports car ...

1.6 Mk 3 Cortina ! Ex rep mobile that I ran until it went to Banger heaven with 180,000 on the clock !

Thanks very much I will give them a shout

Thanks again !
I have e-mailled Bull Motif and await a response but I will look into the other possibilities as well
Rich

Spraying quantity !
Ah Bull Motif never thought of them !
Thankyou sir you are a gentleman !!
Richard

Can anyone guide me to the best place for paint in the East Midlands ?
Sorry if this goes over old ground !
Rich

I know robbin Herberts eh !
Still I have had no answer from the wanted section so ... hey ho - easy come easy go eh !

As BMC points out be careful with the big end bolt you use as a replacement. One of the engines I just rebuilt had a 'mix and match' set of bolts which must have done wonders for the engine balance Thanks for that ! They are all 3/8" x 24 UNF on the ones I have and I will put a mic on the loca...

Con rod is ok I am just clumsy and dropped something on the bolt and clonked the thread !
Thanks

Hi folks,
Just re-building my 948 engine and have got a screwed up big end bolt ! Anyone know where the best place is to get them from ?
Thanks
Richard

Thanks again

Thanks for that. The levers do not appear to have any damage but I have not closely examined them. I was going to replace the clutch anyway. If there is excessive wear on the thrusts would you not feel that ?
Rich

Just pulled the engine out thinking I may have a crank thrust issue as I could feel the vibration through my foot ! The clutch however has a rusty patch that hasn't cleaned up ( Apparently the car had stood for 4 1/2 years ) The clutch thrust does not turn ( All other I have worked with do ! ) is th...

Just spotted the post below from Roli ... DOH !

Hi folks does anyone have an idiots guide to converting from Positive to Negative earth and installing an alternator ?
Sorry if this has been asked a dozen times before !
Rich